| S/N |
Parameters |
Specification |
Results |
Remarks |
|
1. Input requirements
|
| 1.1 |
I/P voltage |
190~265Vac (230V nominal) |
192 ~265Vac |
OK |
| 1.2 |
I/P over current protection (Fuse) |
Fuse 3A / 250V slow blow |
OK |
OK |
| 1.3 |
I/P frequency |
50hz |
50.0hZ |
OK |
| |
|
2. Output characteristics
|
| 2.1 |
DC voltage regulation |
DC O/P voltages shall remain within the regulation ranges shown in the table 2 see below when measured at the load end of the O/P connectors under all line, load & environmental conditions. |
OK |
OK |
| 2.2 |
DC O/P current |
5V-12A, 12V-12A, 3.3V-8A, -12V-0.3A, 5VSB-1.5A (Max wattage at 5V&3.3V is 100W) |
4.9V-11.1A , 12.63V-11.1A, 3.30V-7.0A,-12.56V-0.3A, 5VSB-1.4A |
OK |
| 2.3 |
Line regulation |
ą1% of nominal |
OK |
OK |
| 2.4 |
Ripple & Noise (pk-pk) |
5V=50mV max, 12,-12V = 240mV max, 3.3V =50mV max, 5VSB = 50mV max |
12V=88mV, 3.3mV=28mV,5V=50mV |
OK |
| 2.5 |
AC I/Ppower cord Plug type |
Three pin plug (wall mount) |
|
|
| 2.6 |
O/P connectors |
Main O/P connector should be 20+4 pin Red pin |
1NO,S |
OK |
| |
|
O/P connectors 4 pin for hard disk / CD drive*2 Red pin |
2NO,S |
OK |
| |
|
O/P connector for SATA disk*2 Red pin |
2NO,S |
OK |
| |
|
O/P connector 4 pin for floppy drive*1 Red pin |
1NO,S |
OK |
| |
|
O/P connector 4 pin (12V) for Mother board*1 Red pin |
1NO,S |
OK |
| |
|
O/P connector 6+2pin (PCI-E) *1 Red pin |
1no. |
OK |
| 2.7 |
Power good @230Vac, full load |
100~500mSec |
251.4mS |
OK |
| 2.8 |
Efficiency at F/L with nominal I/P voltage |
Preferably >70% as per IS:14886:2000 |
73.00% |
OK |
| 2.9 |
Short circuit protection |
If O/P short then manual recovery |
OK |
OK |
